At the MOT, the tester checks that every mandatory lamp works, that dipped-beam headlamps are aimed within set limits, and that the lighting and warning lamps on the dashboard behave as they should. A blown headlamp bulb, a beam aimed outside the limits or an unapproved LED or HID conversion is a Major defect, and any Major or Dangerous defect means the car fails.

The rules below apply in England, Scotland and Wales unless we say otherwise. Northern Ireland has its own manual, covered further down.

Headlamp aim

What the tester checks

The tester checks all fitted dipped-beam headlamps. Depending on the lamp design, aim is measured on dipped beam or main beam. Aim outside the permitted limits, an obviously incorrect beam pattern, or aim that cannot be tested is a Major defect.

The aim limits

For a European-type dipped beam, the horizontal cut-off must sit within a band below horizontal. The band depends on how high the centre of the lamp is above the ground.

Headlamp centre heightGreat BritainNorthern Ireland
850 mm or less0.5% to 2.75% below horizontal0.5% to 2.0% below horizontal
Higher than 850 mm1.25% to 2.75% below horizontal1.25% to 2.75% below horizontal

A flat-top beam is acceptable in Great Britain if its entire upper edge falls within the applicable band.

Adjustment and levelling

Testers in Great Britain may make minor aim adjustments during the MOT. They start by leaving the driver’s aim control where it is set. If the beam would fail for being too low, they recheck it with the control at its highest setting. Where the check applies, a headlamp levelling device that does not work is a Major defect.

Headlamp washers

On vehicles first used on or after 1 September 2009, testers inspect any headlamp washers fitted. A washer that does not work is a Major defect on LED or high-intensity discharge (HID) headlamps, and a Minor defect on other headlamp types.

Bulbs and exterior lamps

Headlamp bulbs and LED headlamps

A mandatory headlamp that is missing or fails to illuminate, including because its bulb has blown, is a Major defect. In a headlamp made up of several LED light sources, up to half of them failing is Minor and more than half failing is Major. The lamps in each mandatory pair must also give substantially the same colour and intensity, so two mismatched bulbs can cause a problem.

Brake lights and number plate lights

FaultResult
One stop lamp inoperativeMajor
All stop lamps missing or inoperativeDangerous
Stop lamp with multiple light sources, up to half failingMinor
Stop lamp with multiple light sources, more than half failingMajor
One of several number plate lamps out, others workingMinor
Only number plate lamp, or all of them, failedMajor

Additional stop lamps, including the high-level brake light, are covered where they are connected.

Other exterior lamps

The test also covers mandatory front and rear position lamps, indicators and hazard lights. Some lamps are only checked on cars first used from a certain date:

  • Rear fog lamp: mandatory and tested from 1 April 1980.
  • Reversing lamps: tested where fitted from 1 September 2009.
  • Front fog lamps and original-equipment daytime running lamps: tested where fitted from 1 March 2018.

Our MOT pre-check checklist shows how to run through every lamp at home in a few minutes.

Tip

Ask someone to stand behind the car while you press the brake pedal, select reverse and switch on the rear fog lamp. Checking the high-level brake light and the number plate lamps this way is far easier than trying to spot them in a reflection.

Dashboard warning lights

Lighting checks extend to the dashboard. A missing or inoperative main-beam indicator or rear fog indicator, where it is mandatory, is a Major defect. The main-beam indicator is required on cars first used on or after 1 April 1986. A missing or inoperative mandatory direction indicator or hazard tell-tale is Minor.

Several other warning lamps can also fail the test:

  • Engine management light: it must come on at ignition and then go out, sometimes after the engine starts. A lamp that does not work or shows a fault is Major. The check applies to petrol cars first used from 1 July 2003 and to diesel, gas and bi-fuel cars from 1 July 2008, including hybrids in those fuel groups.
  • ABS, stability control and airbag: an ABS warning that does not work or shows a fault is Major, as is an electronic stability control or airbag (SRS) warning showing a fault.
  • Brakes: a fault shown by the electronic parking brake warning is Major. An illuminated brake fluid warning lamp on its own is Minor.
  • Tyre pressure monitoring: on passenger cars first used on or after 1 January 2012, a malfunctioning or clearly inoperative system is Major.

We cover these in more detail in our guide to warning lights that fail the MOT.

LED and HID conversions

Approved LED bulbs from 14 October 2026

Since 14 October 2026, testers in England, Scotland and Wales can accept an ECE-approved LED replacement bulb, known as LEDr, in an existing halogen headlamp on vehicles in MOT classes 3, 4, 5 and 7. The approval must cover use in that particular lamp, and the vehicle must display the matching approval sticker issued by the manufacturer. The headlamp still has to pass every other applicable check, including beam aim.

The approval sticker

The sticker must be permanently attached to the vehicle and easy for the tester to see. It shows the bulb category and variant, rated voltage, ECE approval number, manufacturer’s name and a security feature such as a hologram. If a required sticker is missing, unreadable, damaged, apparently tampered with or does not match, the headlamp is a Major defect.

Unapproved LED bulbs and HID kits

On vehicles first used on or after 1 April 1986, fitting a HID light source, or an LED bulb that is not approved for that halogen headlamp, is a Major defect. For older vehicles, the MOT does not include this compatibility check, although the other headlamp checks still apply.

Complete replacement headlamps

A complete headlamp unit built to use LED or HID light sources is assessed against the requirements for that type of unit. The bulb conversion defect does not apply to it.

Northern Ireland

Northern Ireland’s Driver and Vehicle Agency (DVA) uses its own Light Vehicle Inspection Manual. The aim band for lower headlamps is tighter, as shown in the table above, and aim outside the bands is a Major defect. Unlike in Great Britain, the DVA manual prohibits adjusting the headlamps during the test.

It has not been confirmed whether Northern Ireland has adopted an equivalent to the October 2026 approved LED bulb rule. The DVSA notice applies to England, Scotland and Wales only.

What could change next

In a parliamentary answer on 18 November 2026, the Department for Transport said September 2027 is the earliest that amended international rules on automatic headlamp levelling could be mandated. It has previously pointed to a transition for new vehicle type approval running from September 2027 to September 2030. Whether the MOT will change for cars already on the road has not been confirmed.

For now, check every lamp before the test and replace like with like. Our list of common MOT failure reasons and the wider MOT guide are good places to start.

MOT due date calculator See when the first and next MOT are due, and how early you can test.
Try it free

Frequently asked questions

Does a blown headlight bulb fail the MOT?

Yes. A mandatory headlamp that is missing or fails to illuminate, including because its bulb has blown, is a Major defect, and a Major defect fails the MOT. The lamps in each mandatory pair must also give substantially the same colour and intensity.

Are LED headlight bulbs legal for the MOT?

From 14 October 2026, in England, Scotland and Wales, an ECE-approved LED replacement bulb (LEDr) can be accepted in an existing halogen headlamp if its approval covers that lamp and the matching approval sticker is displayed. On vehicles first used on or after 1 April 1986, an LED bulb without approval for that halogen headlamp is a Major defect.

Does a brake light out fail the MOT?

An inoperative stop lamp is a Major defect, and if all stop lamps are missing or inoperative the defect is Dangerous. For a stop lamp with several light sources, up to half failing is Minor and more than half failing is Major.

Can the MOT tester adjust my headlights?

In Great Britain, testers may make minor aim adjustments during the MOT. In Northern Ireland, the DVA manual prohibits adjustment during the test.

Does a number plate light fail the MOT?

If the only rear number plate lamp fails, or all of them fail, it is a Major defect. If one of several lamps or light sources is out and the others still work, it is a Minor defect.

Sources

PlateScout is independent and not affiliated with the DVLA, DVSA, TfL or any government body. Rules and rates change: always check the official source before you act.

Check a number plate now

See when and where a car was first registered, free and without signing up.

UK

Works for current, prefix and suffix plates.