Before an MOT, check the parts you can inspect yourself: tyre tread and condition, every exterior light, the number plates, wipers and washers, mirrors, seat belts, the horn and any dashboard warning lights. Most of these checks take a few minutes on your drive and need little more than a tread depth gauge and a helper. Sorting a blown bulb or a split wiper blade beforehand is far easier than arranging repairs after a failure.
Why a pre-MOT check makes sense
The MOT covers a long list of items, and a good number of them can be checked by any driver without lifting the car. The checklist below follows the areas set out in the DVSA inspection manual for cars in Great Britain. Northern Ireland uses the DVA’s own inspection manual and has different appointment arrangements, which are covered further down. If you want to know what happens on the day itself, our guide to the MOT test explained walks through it.
A pre-check does not replace the test, and it will not find hidden problems underneath the car. What it can do is catch the obvious faults that would otherwise turn a routine appointment into a failure and a retest.
Tyres and wheels
Tread depth
Measure the tread on all four road tyres. The main grooves must be at least 1.6 mm deep across the central three-quarters of the tread width, all the way round each tyre. Check several points around each tyre rather than a single spot. For the full detail on damage, sizes and mixing tyre types, see our guide to MOT tyre rules.
Damage and wheels
Look along each tyre for cuts, bulges and exposed cords. Check the visible parts of the wheel rims for cracks or distortion, and look for missing wheel nuts or bolts where you can see them. While you are there, check the tyre pressures against the manufacturer’s guidance.
Tyre pressure warning
If a tyre pressure warning shows on the dashboard, check the pressures first. If the warning stays on at the correct pressures, consult the handbook or have the system checked. In Great Britain, the MOT checks the tyre pressure monitoring system on applicable passenger cars first used on or after 1 January 2012.
Lights, reflectors and number plates
Switch on the exterior lights and walk around the car. Check the following, as applicable to your car:
- sidelights, dipped beams and main beams
- tail lights and rear fog lights
- indicators and hazard warning lights
- rear number plate lights
- reversing lights
Ask someone to stand behind the car while you press the brake pedal, so they can confirm the brake lights work, including the high-level lamp if one is fitted. Look for cracked or loose lamps and damaged rear reflectors.
Then clean both number plates. Check that they are secure, show the same registration and can be read easily. Look for damaged characters, incorrect spacing, or fixings that obscure the registration.
Converted LED headlamps
Since 14 October 2026, an approved LED replacement bulb can be accepted in a compatible halogen headlamp in Great Britain. The bulb must be approved for that lamp and the required manufacturer-issued approval sticker must be present. If your headlamps have been converted, check that the sticker is there before the test.
Windscreen, wipers and mirrors
Top up the screenwash, then use the washers and wipers together. The jets should deliver enough fluid, the blades should clear the glass, and the wipers should keep moving while switched on. Look for split, worn or loose blades.
Next, check the driver’s view. Look for chips and cracks in the area the wipers sweep, and remove any accessories that obstruct the view. In Great Britain, testers look for damage over 10 mm in zone A, which is the 290 mm wide strip centred on the steering wheel within the swept area, and over 40 mm elsewhere in the swept area. Damage warrants a failure when it significantly affects the driver’s view of the road. Our article on windscreen chips and the MOT covers this in more depth.
Finally, clean the mirrors and check that they are secure, adjust where they are designed to, and give a clear view. Where cameras replace mirrors, check that the display works and gives a clear view.
Seats, belts, controls and warning lights
Seat belts
Fasten and release each accessible seat belt. Give the fastened belt a firm tug to check the buckle holds, then make sure the belt retracts after release. Look for cuts and fraying along the webbing. Clear items off folded seats so the tester can reach every belt.
Seats, doors, bonnet and boot
Make sure the driver’s seat adjusts and locks securely, and that seat backs latch upright. The front doors should open from inside and outside, and the rear doors from outside. Open and securely close the bonnet and the boot or tailgate.
Horn and dashboard warnings
Sound the horn while parked. After starting the car or putting it into ready mode, look for any warning that indicates a fault with the brakes, ABS, stability control, power steering, airbags, tyre pressure monitoring or engine management, as applicable. Use the handbook to identify any symbol you are unsure about. Our guide to MOT warning light rules explains how these warnings are treated at the test.
Bodywork, fluids and test-day preparation
Walk around the car and look underneath from ground level. Look for loose bumpers or panels, sharp edges, serious corrosion, fresh leaks or a visibly loose exhaust. Have suspected structural corrosion, fuel leaks or exhaust defects checked before the appointment.
On a petrol or diesel car, check the engine oil as the handbook describes, make sure there is enough fuel to complete the test, and confirm that the fuel cap fastens securely. If the cap locks, bring the key. DVSA advises arriving with a fully warmed-up diesel engine and telling the tester if you suspect the smoke test could damage it.
Clear access for the tester too. Remove or secure loose loads and clean off enough dirt for the car to be examined. In Great Britain, a tester can refuse to carry out the test if dirt or a load prevents a proper inspection, or if a lack of fuel or oil makes the car unfit to drive for the test.
Look at the advisories from your last MOT before you book, and check whether the underlying issues have been dealt with. Our guide to MOT advisories explains what they mean and how to act on them.
Quick pre-MOT checklist
| Area | What to check | Key detail |
|---|---|---|
| Tyres | Tread, cuts, bulges, cords, pressures | At least 1.6 mm across the central three-quarters |
| Wheels | Rims, visible nuts and bolts | No cracks, distortion or missing fixings |
| Lights | All exterior lamps, brake lights, reflectors | Ask a helper to watch the brake lights |
| Number plates | Clean, secure, matching, readable | No damaged characters or incorrect spacing |
| Windscreen | Chips and cracks in the swept area | Over 10 mm in zone A, over 40 mm elsewhere |
| Wipers and washers | Blades, jets, screenwash level | Blades must clear the glass |
| Mirrors | Secure, adjustable, clear view | Camera displays must work |
| Seat belts | Buckles, retraction, webbing | No cuts or fraying |
| Warning lights | Brakes, ABS, airbags, engine and more | Identify any warning in the handbook |
| Fuel and oil | Enough fuel, oil level, fuel cap | Bring the key for a locking cap |
Check the due date and the fee
For a standard private car in Great Britain, the first MOT is normally due at three years, then every year after that. You can work out your next date with our MOT due date calculator. The maximum fee for a full Class 4 car test is £54.85.
Northern Ireland appointments
In Northern Ireland, private cars normally have their first MOT at four years and are tested every year after that. Check your car’s actual expiry date before booking with the DVA. From 1 June 2026 to 31 May 2027, the DVA automatically applies Temporary Exemption Certificates to eligible private cars with a valid Northern Ireland MOT that were first registered from 1 June 2019 to 31 May 2020 or from 1 June 2021 to 31 May 2022.
Changes to watch
DVSA’s business plan for 2026/27 announces further testing of driver assistance systems and a review of electric-vehicle checks, including high-voltage systems and battery integrity. The start date and final inspection rules for any resulting changes to the car MOT have not been confirmed.
Separately, the government plans to use verified MOT mileage readings for Electric Vehicle Excise Duty from 1 April 2028, which gives the mileage recorded at each test extra importance for electric car owners.
Frequently asked questions
What should I check on my car before an MOT?
Check tyre tread and condition, all exterior lights and the brake lights, both number plates, wipers and washers, mirrors, seat belts, the horn and any dashboard warning lights. Also look for loose panels, leaks or a loose exhaust, and make sure there is enough fuel and oil for the test.
What is the minimum tyre tread depth for an MOT?
The main grooves must be at least 1.6 mm deep across the central three-quarters of the tread width, all the way round each tyre. Check all four road tyres at several points, not just one spot.
Can an MOT tester refuse to test a dirty car?
Yes. In Great Britain, a tester can refuse the test if dirt or a load prevents a proper inspection, or if a lack of fuel or oil makes the car unfit to drive for the test. Clean off enough dirt and remove or secure loose loads before the appointment.
Will a windscreen chip fail the MOT?
It can. In Great Britain, testers look for damage over 10 mm in zone A, the 290 mm wide strip centred on the steering wheel within the swept area, and over 40 mm elsewhere in the swept area. Damage warrants failure when it significantly affects the driver's view of the road.
When is a car's first MOT due?
For a standard private car in Great Britain, the first MOT is normally due at three years, then every year. In Northern Ireland, private cars normally have their first MOT at four years and are tested annually after that.
Sources
- DVSA: MOT inspection manual for cars and light commercial vehicles
- DVSA: MOT inspection manual, axles, wheels, tyres and suspension
- DVSA: MOT inspection manual, visibility
- DVSA: Car parts checked at an MOT
- DVSA: MOT test fees and appeals poster
- DVSA: MOT special notice 05-26, approved LED replacement bulbs in halogen headlamps
- Department for Infrastructure: Biennial MOT test consultation
PlateScout is independent and not affiliated with the DVLA, DVSA, TfL or any government body. Rules and rates change: always check the official source before you act.
Check a number plate now
See when and where a car was first registered, free and without signing up.