In the UK, Type 2 is the standard connector for AC charging at homes and public charge points, and CCS Combo 2 (CCS2) is the public standard for high-power DC rapid charging. CHAdeMO is a separate DC connector used by some older EVs. Check which inlet your car has and you will know which cable to carry and which rapid chargers you can use.
The three connectors at a glance
Electric cars can charge on alternating current (AC), which is what typical home and on-street units supply, or on direct current (DC), which is used for rapid and ultra-rapid charging. Each connector is built for one or both of these.
| Connector | Type of charging | Typical UK power | Cable |
|---|---|---|---|
| Type 2 (Mennekes) | AC | 3.7 to 7.4 kW at typical home, workplace and on-street units; 22 kW three-phase; some 43 kW | Bring your own at a socket; tethered points have one attached |
| CCS Combo 2 (CCS2) | DC, and the car's inlet also takes a Type 2 plug for AC | Rapid and ultra-rapid, up to what the car can accept | Attached to the charger |
| CHAdeMO | DC | 50 kW is the most common rating | Attached to the charger |
For a broader introduction to charging speeds and where to charge, see our guide to electric car charging in the UK.
Type 2: the standard for AC charging
Type 2, also called Mennekes, is the standard seven-pin connector for alternating current charging at UK homes and public charge points. Typical home, workplace and on-street units supply 3.7 to 7.4 kW. Three-phase units can supply 22 kW, and some less common installations offer 43 kW.
If you are planning a charger at home, our guide to home EV charger installation covers the practical side.
Which cable to bring
Public Type 2 charge points come in two forms. At a Type 2 socket, you plug in your own cable, so you need one that matches both the socket and your car. That usually means a Type 2 to Type 2 cable. A car with a Type 1 AC inlet needs a Type 2 to Type 1 cable for the same socket.
A tethered charge point is different: it has its own cable attached, so you plug that straight into the car.
CCS Combo 2: the standard for rapid DC charging
CCS stands for Combined Charging System. The UK public charging standard for high-power DC charging is CCS Combo 2, also called CCS2.
The design is neat. The car’s Combo 2 inlet accepts an ordinary Type 2 plug in its upper section for AC charging. A CCS2 plug adds two large DC contacts below that section for rapid or ultra-rapid charging. In other words, a car with a CCS2 inlet uses the same port for slower AC charging at home and for rapid DC charging on a long journey. Our article on rapid charging explains how DC charging speeds work in practice.
Example: the 2026 Nissan LEAF
The all-new UK Nissan LEAF uses CCS2. Nissan specifies peak DC charging of 105 kW for the 52 kWh version and 150 kW for the 75 kWh version. These are the car’s own specifications, describing what it can accept at its peak.
CHAdeMO: the older DC standard
CHAdeMO is a separate DC connector used by some older EVs. It requires a matching vehicle inlet for a direct connection, so a car with a CHAdeMO inlet cannot simply plug into a CCS2 connector, or the other way round.
According to Zapmap’s UK connector guide, 50 kW is the most common CHAdeMO charge point rating. Some compatible cars can accept more. For example, Nissan listed the UK 2019 LEAF e+ as compatible with both 50 kW and 100 kW CHAdeMO chargers.
Check the LEAF’s model year and inlet
The Nissan LEAF is a good example of why model year matters. The 2019 LEAF e+ uses CHAdeMO for rapid charging, while the all-new 2026 LEAF uses CCS2. If you are looking at an older EV, our used electric car buying guide covers the other checks worth making.
Public rapid DC chargers provide an attached cable, so you do not need to carry one for DC charging. What you do need to check is the connector listed for the charger before you travel.
Before a long journey, check the connector type listed for each rapid charger on your route, not just its location and power. A CHAdeMO car needs a charger that offers CHAdeMO, and a CCS2 car needs one that offers CCS2.
What UK rules say about connectors
Minimum connector standards
For public charge points within scope that were deployed or renewed after 17 November 2017, the Alternative Fuels Infrastructure Regulations require at least Type 2 for normal-power and high-power AC charging, and CCS Combo 2 for high-power DC charging. Operators can offer additional connectors on top of these, including CHAdeMO.
Open connector data
The Public Charge Point Regulations 2023 require operators to make connector-type data openly available. That is the information to look for when you are choosing where to stop. Our guide to EV charging apps and cards covers the tools drivers use to find and pay for charging.
Is CHAdeMO being phased out?
If you drive a CHAdeMO car, this is the question that matters most. In October 2026, the Department for Transport told Parliament that some operators continued to provide CHAdeMO.
One network has made public commitments. In July 2026, InstaVolt said every new site then in development would include CHAdeMO. In October 2026, it reiterated its commitment to at least one CHAdeMO connector at every site.
No UK-wide date for withdrawing CHAdeMO has been confirmed, including any deadline in 2027. The October 2026 parliamentary answer gave no withdrawal date. For now, CHAdeMO remains an extra that operators can choose to offer, while Type 2 and CCS2 are the minimum standards at public charge points in scope.
For more on running an electric car, from charging to tax, see our electric cars guide.
Frequently asked questions
What charging connector does my electric car use in the UK?
For AC charging, the UK standard connector is Type 2. For high-power DC rapid charging, the public standard is CCS Combo 2, while some older EVs use CHAdeMO instead. Check your car's charging inlet to confirm which it has.
What is the difference between Type 2 and CCS?
Type 2 is the seven-pin connector for AC charging. A CCS Combo 2 inlet on the car accepts a Type 2 plug in its upper section for AC, and a CCS2 plug adds two large DC contacts below that section for rapid or ultra-rapid charging.
Do I need my own cable to charge an electric car?
At a public Type 2 socket you need a cable that matches both the socket and your car, usually Type 2 to Type 2. Tethered charge points and public rapid DC chargers have their own attached cable.
Is CHAdeMO being phased out in the UK?
No UK-wide date for withdrawing CHAdeMO has been confirmed. In October 2026 the Department for Transport told Parliament that some operators continued to provide it, and InstaVolt reiterated its commitment to at least one CHAdeMO connector at every site.
How fast is Type 2 charging?
Typical home, workplace and on-street Type 2 units supply 3.7 to 7.4 kW. Three-phase units can supply 22 kW, and some less common installations offer 43 kW.
Sources
- Zapmap: EV connector types
- Office for Zero Emission Vehicles: Alternative Fuels Infrastructure Regulations report 2023
- Alternative Fuels Infrastructure Regulations 2017
- GOV.UK: regulations for alternative fuels infrastructure
- GOV.UK: Public Charge Point Regulations 2023 guidance
- UK Parliament written answer on CHAdeMO charge points
- Nissan GB: all-new Nissan LEAF specifications
- Nissan GB: Nissan LEAF e+ specifications
PlateScout is independent and not affiliated with the DVLA, DVSA, TfL or any government body. Rules and rates change: always check the official source before you act.
Check a number plate now
See when and where a car was first registered, free and without signing up.