Check your engine oil regularly and before any long journey, using the method your handbook describes: a dipstick reading between the MIN and MAX marks, or the car’s electronic oil-level display. Change the oil and filter at the intervals in your service schedule, using whichever of the mileage or time limit comes first, and take used oil to a site that accepts it rather than pouring it away.
When to check your engine oil
Highways England’s advice for drivers is simple: check the engine oil regularly and before a long journey. It only takes a few minutes on the driveway, and it is one of the easiest ways to spot a developing problem early.
Pay attention to how often you reach for the oil bottle. If you are topping up more often than usual, Highways England advises having the car checked by a garage.
The most important rule is to follow the handbook for your exact engine. Cars differ in a few key ways:
- Some have a traditional dipstick, while others display the oil level electronically.
- The handbook says whether the engine should be cold or warm when you check.
- It also tells you how long to wait after switching the engine off before taking a reading.
Checking under the wrong conditions can give a misleading result, so read that page of the handbook once and keep the details in mind. Our car maintenance guide covers the other routine checks worth doing at the same time.
How to check the oil level
Cars with a dipstick
- Park on level ground and switch off the engine.
- Wait for the time given in your handbook.
- Pull out the dipstick and wipe it clean.
- Push it fully back in, then withdraw it again.
- Read the level: the oil should sit between the MIN and MAX marks.
Cars with an electronic oil-level display
Many cars have no dipstick for the driver to use. Instead, you check the oil level through the display, as directed in the handbook. A reading may be unavailable until the car meets the required conditions, so do not assume the system is faulty if it asks you to wait.
If the display gives a specific refill quantity, add only that amount. Pouring in more than it asks for risks taking the level too high.
| Method | How you read it | What to watch for |
|---|---|---|
| Dipstick | Wipe, push fully back in, withdraw and read | Oil should sit between MIN and MAX |
| Electronic display | Use the display as the handbook directs | A reading may wait until conditions are met |
| Refill prompt | The display shows a quantity to add | Add only the amount shown |
How to top up engine oil
Use oil that meets the manufacturer’s specification and viscosity grade for your engine. Both are listed in the handbook. A bottle that only looks similar on the shelf may not meet the specification your engine needs, so match the details rather than the brand or colour of the label.
To top up:
- Open the oil filler cap on the engine.
- Add oil gradually through the filler.
- Recheck the level as the handbook directs.
- Refit the cap securely.
Keep the level at or below the MAX mark. The aim is to sit within the marked range, not above it.
Add a little at a time and recheck before pouring more. It is easy to add oil and much harder to get it back out once you have gone past MAX.
What to do if an oil warning comes on
If a low oil pressure warning appears while you are driving, pull over as soon as it is safe, switch off the engine and arrange recovery. Do not try to nurse the car on to the next garage.
Some cars also have a separate low oil-level message, which is not the same thing as a pressure warning. Use the handbook to identify exactly which warning you are seeing. Our dashboard warning lights guide explains the common symbols and how seriously to take each one.
Changing the oil and filter
How often to change it
Follow the oil and filter intervals in the service schedule for your engine. Where the schedule gives both a mileage and a time limit, use whichever comes first. A car that covers very few miles still needs its oil changed when the time limit is reached.
As an example, the model-year 2025 Morgan Plus Four handbook specifies an oil change every 10,000 miles or one year, with a new filter at each oil change. Other cars have different intervals, so treat that as an illustration rather than a rule for your own car. If a garage looks after your car, check that the oil and filter are on the job list; our guide to what a car service includes explains what to ask about.
The drain-plug method
If you change the oil yourself, follow the procedure for your exact engine. Owner’s manuals such as Nissan’s for the 2024 Juke illustrate the basic steps:
- Catch the old oil in a drain pan.
- Renew the drain plug seal and the filter as specified.
- Refill with the specified oil and the specified quantity.
- Check the level.
- Look for leaks at the drain plug and the filter.
That final leak check is easy to skip when the job seems finished, but it is the step that tells you the plug and filter have sealed properly.
Working safely under the car
If you need to work underneath a raised car, use suitable axle stands on firm, level ground. Never get under a car supported only by a jack, however briefly.
Take care with the oil itself. Drained oil can be hot, and prolonged skin contact with used oil can cause skin disorders, so avoid getting it on your skin and wash off any that does.
Disposing of used oil and filters
Used engine oil must never go down a drain or onto the ground. Put it in an undamaged container with a secure lid and take it to a waste-oil bank or a household recycling centre that accepts it. Check which sites accept it before you travel.
The Environment Agency classifies both used engine oil and oil filters as hazardous waste. Check with your council whether your chosen site accepts used filters as well as oil, so you do not make a wasted trip.
Empty oil bottles in England
Under the household recycling rules in England that took effect on 31 March 2026, waste collectors are exempt from the requirement to collect metal packaging and plastic bottles that have held engine oil. In practice, do not assume an empty oil bottle belongs in your recycling bin. Follow your council’s instructions for empty containers.
Defra’s announced extension from 31 March 2027 covers plastic films and bags. Any change to the engine-oil packaging exemption has not been confirmed.
Oil leaks and the MOT
Oil leaks also matter at MOT time. In Great Britain, DVSA instructs testers to fail a car if a relevant fluid leak creates a pool more than 75 mm across within five minutes, or if several leaks together reach the equivalent rate.
A tester can also refuse to carry out the MOT at all if a fluid leak is excessive, or if a lack of oil makes the car unfit to drive for the test. Checking the level and looking under the car for fresh drips is a sensible part of any pre-MOT routine. DVSA has not confirmed any forthcoming change to the fluid-leak rule.
For more on why cars fail, read our guide to common MOT failure reasons, and use the MOT due date calculator to plan your next test.
Frequently asked questions
How often should I check my engine oil?
Check it regularly and before any long journey. If you find you are topping up more often than usual, have the car checked by a garage.
Should I check engine oil when the engine is hot or cold?
It depends on the car. Your handbook says whether the engine should be cold or warm and how long to wait after switching it off, so follow it to get a valid reading.
How often should the engine oil and filter be changed?
Follow the service schedule for your engine and use whichever of the mileage or time limit comes first. As one example, the model-year 2025 Morgan Plus Four handbook specifies 10,000 miles or one year, with a new filter at each oil change.
What should I do if the oil pressure warning comes on while driving?
Pull over as soon as it is safe, switch off the engine and arrange recovery. Check the handbook to identify the warning, as some cars also have a separate low oil-level message.
Can an oil leak fail the MOT?
Yes. In Great Britain, testers fail a car if a relevant fluid leak creates a pool more than 75 mm across within five minutes, or if several leaks together reach the equivalent rate. A tester can also refuse to test a car if a leak is excessive or a lack of oil makes it unfit to drive.
Sources
- Highways England: safety tips for motorway drivers
- Volvo V60 handbook: checking the oil level
- Morgan Plus Four handbook (MY25)
- HSE: Safe working in vehicle maintenance and repair
- Environment Agency: vehicle and oily wastes
- Defra: Simpler Recycling in England
- DVSA MOT inspection manual: nuisance
PlateScout is independent and not affiliated with the DVLA, DVSA, TfL or any government body. Rules and rates change: always check the official source before you act.
Check a number plate now
See when and where a car was first registered, free and without signing up.