The MOT emissions test checks what comes out of your exhaust. In Great Britain, petrol cars get a gas analyser test that measures carbon monoxide, hydrocarbons and, on newer cars, lambda, while diesel cars get a smoke opacity test that measures how much light the exhaust smoke absorbs. Testers also check the diesel particulate filter (DPF), other emissions equipment and the engine management light.

Which car gets which test

The type of test depends on the fuel, the car’s age and, for diesels, whether a manufacturer’s smoke value is available. Hybrids are treated differently, as covered further down.

CarMain emissions check in Great Britain
Petrol, first used from 1 August 1975Tailpipe gas test
Diesel, first used from 1 January 1980Metered smoke opacity test
Diesel, manufactured before 1980Visual smoke check at idle and during acceleration
Hybrid, including mild hybridExempt from the gas analyser and opacity tests

Petrol cars: the gas analyser test

Petrol cars first used from 1 August 1975 generally receive a tailpipe gas test. The non-catalyst test measures carbon monoxide (CO) and hydrocarbons (HC) at idle. The basic emissions test also measures lambda, which indicates the air-to-fuel ratio.

Basic emissions test limits

Engine speedLimit
Fast idle, 2,500 to 3,000 rpmCO no more than 0.2%
Fast idle, 2,500 to 3,000 rpmHC no more than 200 parts per million (ppm)
Fast idle, 2,500 to 3,000 rpmLambda between 0.97 and 1.03
Idle, 450 to 1,500 rpmCO no more than 0.3%

If the car exceeds a basic limit, that is not automatically the end of the story. The tester follows the DVSA flowcharts to select the applicable full catalyst or non-catalyst test.

Older petrol cars

Older petrol cars have more generous idle limits:

  • first used from 1 August 1975 to 31 July 1986: 4.5% CO and 1,200 ppm HC
  • first used from 1 August 1986 to 31 July 1992: 3.5% CO and 1,200 ppm HC

For cars first used from 1 August 1992, the limits depend on the test route and may be specific to the model.

Visible smoke and emissions equipment

Dense blue or clearly visible black smoke at steady idle can fail the MOT, with limited exceptions for certain older and two-stroke engines.

The tester also looks at the emissions equipment itself. Missing, obviously modified or defective original emissions equipment is a major defect on cars first used from 1 September 2002. For earlier cars, that equipment rule applies where a full catalyst test could apply.

Diesel cars: the smoke opacity test

What is measured

An approved smoke meter measures how much light the exhaust smoke absorbs while the engine accelerates under no load. The reading is expressed in inverse metres (m⁻¹). Cars first used from 1 January 1980 generally receive this metered test. Diesels manufactured before 1980 receive a visual smoke check at idle and during acceleration instead.

Which limit applies

Where a manufacturer’s smoke value is available on the vehicle plate or sticker, the tester uses it and adds 0.05 m⁻¹ when entering it into the meter. For example, a plate value of 0.50 m⁻¹ is entered as 0.55 m⁻¹.

When no manufacturer’s value is available, default limits apply, based on the date of first use:

Date of first useDefault limit
Before 1 July 2008, non-turbo2.5 m⁻¹
Before 1 July 2008, turbo3.0 m⁻¹
1 July 2008 to 31 December 20131.5 m⁻¹
From 1 January 20140.7 m⁻¹

The limits tighten sharply for newer cars. If you are not sure which emissions standard your car was built to, our guide to Euro emissions standards explains the background.

How the readings are judged

An initial reading at or below 60% of the applicable limit qualifies for a pass. Otherwise, the manual provides for averaging three consecutive readings, with up to six accelerations in total.

Exceeding the applicable opacity limit is a major defect. Smoke or vapour thick enough to obscure other road users’ view is a dangerous defect.

DPF checks

A diesel particulate filter traps particles from diesel exhaust. A missing factory-fitted filter causes an MOT failure. The government’s guidance points out that a car can meet the smoke limit while still emitting harmful levels of fine particles, which is why the presence of the filter matters, not just the smoke reading.

The tester also looks for signs of interference:

  • evidence of DPF tampering is a major defect
  • a filter that has clearly been cut open and rewelded is grounds for failure, unless the presenter can show a valid reason, such as cleaning
  • visible smoke of any colour during the metered check is a major defect on a DPF-equipped car

Our guide to MOT DPF removal rules goes further into what counts as tampering, and DPF problems and regeneration covers how the filter is kept working day to day.

Good to know

If your diesel has had its DPF cleaned and the filter casing shows signs of being cut and rewelded, bring evidence of the work to the test. A valid reason such as cleaning is the exception the tester can accept.

The engine management light and hybrids

The engine malfunction indicator lamp, often called the engine management light, is checked on ordinary petrol cars first used from 1 July 2003 and diesel cars first used from 1 July 2008, including hybrids. Where the check applies, a lamp that indicates a fault or fails to operate is a major defect. Our article on MOT warning light rules covers the other dashboard lights the tester looks at.

Hybrids, including mild hybrids, are exempt from the petrol gas analyser test and the diesel opacity test. The warning lamp check still applies to them.

Northern Ireland

Northern Ireland’s Driver and Vehicle Agency (DVA) handles diesel emissions differently. It uses visual emissions and exhaust checks, including a check for the factory-fitted DPF, and checks the engine malfunction indicator lamp where applicable. Routine metered smoke testing for diesel cars was suspended in 2006.

In July 2026, the High Court declared that the Department’s failure to carry out the required diesel emissions testing breached its statutory obligations. The DVA is preparing particle number (PN) testing at existing centres for eligible modern diesel cars first registered from 1 January 2013, and metered smoke testing for older diesels at Hydebank and Mallusk. Start dates for these tests have not been confirmed.

Changes on the horizon in Great Britain

The government has announced further investigation into a more effective test for diesel particulate emissions. There is no confirmed start date or MOT pass limit for routine particle counting.

Separately, the Department for Transport has consulted on stronger requirements to maintain emissions control systems and address tampering. The consultation envisaged legislation in summer 2027 with a proposed six-month lead-in. The final legislation and its start date have not been confirmed, and the proposal concerns in-use emissions law and enforcement rather than the MOT itself.

For a full overview of the rest of the test, see the MOT test explained.

MOT due date calculator See when the first and next MOT are due, and how early you can test.
Try it free

Frequently asked questions

What are the MOT emissions limits for a petrol car?

In the basic emissions test, CO must be no more than 0.2%, HC no more than 200 ppm and lambda between 0.97 and 1.03 at fast idle. At normal idle, CO must be no more than 0.3%. If a car exceeds a basic limit, the tester moves on to the applicable full catalyst or non-catalyst test.

What is the diesel smoke limit for an MOT?

The tester uses the manufacturer's smoke value from the vehicle plate or sticker where available, adding 0.05 m⁻¹. Without one, the default limit is 0.7 m⁻¹ for diesels first used from 1 January 2014, 1.5 m⁻¹ from 1 July 2008 to 31 December 2013, and 2.5 m⁻¹ (non-turbo) or 3.0 m⁻¹ (turbo) before 1 July 2008.

Will a car fail the MOT without a DPF?

Yes. A missing factory-fitted diesel particulate filter causes an MOT failure, and evidence of DPF tampering is a major defect. Visible smoke of any colour during the metered check is also a major defect on a DPF-equipped car.

Do hybrid cars have an MOT emissions test?

Hybrids, including mild hybrids, are exempt from the petrol gas analyser test and the diesel opacity test. The engine malfunction indicator lamp is still checked on hybrids where that check applies.

Does Northern Ireland do diesel smoke tests at the MOT?

Routine metered smoke testing for diesel cars in Northern Ireland was suspended in 2006, and the DVA uses visual emissions and exhaust checks instead, including a check for the factory-fitted DPF. The DVA is preparing new diesel tests, but start dates have not been confirmed.

Sources

PlateScout is independent and not affiliated with the DVLA, DVSA, TfL or any government body. Rules and rates change: always check the official source before you act.

Check a number plate now

See when and where a car was first registered, free and without signing up.

UK

Works for current, prefix and suffix plates.