At the MOT, the tester measures how hard each wheel brakes, usually on a roller or plate brake tester, and the result is turned into an efficiency figure based on the car’s weight. For a typical passenger car, the footbrake must reach 58% if the car was first used on or after 1 September 2010, or 50% if it is older, and the handbrake must usually reach 16%. The wheels on each axle must also brake evenly, and the tester inspects pads, discs and brake warning lights.
The details below apply to cars tested in England, Scotland and Wales. Northern Ireland uses a separate manual with some different figures, which we cover near the end.
How the brake test works
Roller and plate testers
The tester normally uses the test station’s main brake tester, which can be a set of rollers or a plate tester. Both record the braking effort at each wheel. The MOT testing service usually calculates efficiency and imbalance from those readings automatically.
Efficiency is the combined braking effort for the system being tested, expressed as a percentage of the car’s test weight. On rollers, there is one shortcut: if more than half of the wheels braked by that system lock, the efficiency requirement is treated as met.
When a decelerometer is used
Some cars are not suitable for rollers or plates because of their drivetrain, transmission or braking system. In that case the tester can use a decelerometer, a meter that measures how quickly the car slows down, for all or part of the test. For the footbrake, the tester brakes progressively from about 20 mph on a level road and checks whether the car pulls sharply to one side.
Footbrake efficiency
The MOT manual calls the footbrake the service brake. For an M1 passenger car with a service brake working on at least four wheels, the minimums are:
| Car first used | Minimum efficiency (Major below this) | Dangerous below |
|---|---|---|
| On or after 1 September 2010 | 58% | 29% |
| Before 1 September 2010 | 50% | 25% |
A result below the minimum is a Major defect and the car fails. A result below half the minimum is Dangerous.
Imbalance between left and right
Even if the total figure is good, a car that brakes harder on one side can pull under braking. The tester compares the wheels on the same axle:
- If the weaker wheel produces less than 70% of the stronger wheel’s effort, the imbalance is a Major defect.
- On a steered axle, usually the front, less than 50% is Dangerous.
There are two situations where the tester ignores the imbalance: when the lower reading was caused by the wheel locking, or when the higher reading is 40 kg or less on the tester.
Problems at individual wheels
The tester also looks at how each wheel behaves while braking:
- Insufficient braking effort at a wheel is Major.
- A wheel that records no braking effort at all is Dangerous.
- Severe grabbing, an abnormal delay before the brake bites, or excessive fluctuation as the wheel turns are Major.
- Significant braking effort with the brake released, meaning a brake that is binding, is also Major.
The handbrake or parking brake
Efficiency
| Parking brake result | Defect |
|---|---|
| 16% or more | Pass |
| Below 16% | Major |
| Below 8% | Dangerous |
| Fails to operate on one side | Major |
If the parking brake has already been tested as the secondary brake on a car with a single-line braking system, the secondary brake requirements apply instead.
How it is tested
On rollers, the tester records the peak effort and whether the wheels lock. A gradient test, which checks whether the parking brake holds the car on a slope, is kept for vehicles that cannot be tested on the main brake tester or with a decelerometer.
The tester also checks the controls. A ratchet that fails to hold, or obviously excessive lever travel that points to incorrect adjustment, is a Major defect.
Electronic parking brakes
An electronic parking brake can only be tested with a decelerometer where specific testing advice allows it. A malfunction shown by the electronic parking brake warning is a Major defect. Our guide to MOT warning lights explains which other dashboard lamps can cause a fail.
Discs and pads
The tester inspects the friction parts where they can be seen.
| Component and condition | Result |
|---|---|
| Pad or lining worn down to the physical wear indicator | Major |
| Pad or lining contaminated with oil or grease | Major |
| Friction material below 1.5 mm, missing or incorrectly fitted | Dangerous |
| Disc or drum with significant, obvious wear | Major |
| Disc or drum contaminated with oil or grease | Major |
| Disc or drum insecure, fractured, missing or likely to fail | Dangerous |
An illuminated pad-wear warning light does not fail the MOT by itself, and a disc measuring below the manufacturer's recommended thickness limit is not an automatic failure either. The tester judges the actual condition of the parts against the defects in the table above.
If your pads or discs are getting thin, our article on brake pad and disc replacement explains what is involved. If the tester notes something about your brakes without failing the car, our guide to MOT advisories explains what that means.
Northern Ireland
In Northern Ireland, the Driver and Vehicle Agency (DVA) normally uses rollers, and a decelerometer where a roller test is unsuitable. The figures differ slightly from Great Britain.
| Check | Northern Ireland rule |
|---|---|
| Footbrake, M1 car first used from 1 January 2012 | 58% minimum |
| Footbrake, earlier M1 car | 50% minimum |
| Parking brake, split braking system | 16% minimum |
| Parking brake, single-line system | 25% minimum |
| Roller imbalance on an axle | Over 30% is Major |
| Pad or lining | Insecure or less than 1.5 mm at any point is Dangerous |
The footbrake figures apply to M1 cars with a footbrake on at least four wheels and a parking brake on at least two. Below the applicable minimum is Major, and below half of it is Dangerous. In a decelerometer test, a severe steering pull or appreciable swerve under footbrake braking is Dangerous, and excessive deviation under parking braking is Major. A disc or drum that is cracked, excessively scored, pitted or worn, seriously weakened, insecure, contaminated or has a significantly reduced braking contact area is Major.
Changes for 2026/27
There have been no announced changes to the passenger car limits for efficiency, imbalance, discs or pads. DVSA’s business plan for 2026/27 describes ongoing work to modernise MOT standards, but no new brake thresholds have been confirmed. Two technical updates have already taken effect:
- On 22 September 2026, DVSA clarified how test stations measure the roller brake tester floor plate when part of the standing area is outside the building.
- On 4 August 2026, DVSA clarified electronic parking brake test procedures for affected Jaguar and Land Rover models.
For an overview of everything else checked on the day, see our MOT guide.
Frequently asked questions
What brake efficiency do you need to pass an MOT?
For a passenger car with a service brake on at least four wheels, the footbrake must reach 58% if the car was first used on or after 1 September 2010, or 50% if it was first used before that date. Below the minimum is a Major defect, and below half of it is Dangerous.
What is the handbrake minimum for the MOT?
The usual parking brake minimum is 16%. A result below 16% is a Major defect and below 8% is Dangerous. A parking brake that fails to operate on one side is also Major.
How much brake imbalance is allowed at the MOT?
The tester compares the wheels on each axle. If the weaker wheel produces less than 70% of the stronger wheel's effort, it is a Major defect. On a steered axle, less than 50% is Dangerous.
Does a brake pad warning light fail the MOT?
An illuminated pad-wear warning on its own does not cause a failure. However, pads worn down to the physical wear indicator are a Major defect, and friction material below 1.5 mm is Dangerous.
Do discs below the minimum thickness fail the MOT?
A disc reading below the manufacturer's recommended thickness limit does not on its own trigger a failure. Significant, obvious wear or contamination with oil or grease is a Major defect, and an insecure, fractured or missing disc is Dangerous.
Sources
- DVSA MOT inspection manual, section 1: Brakes
- DVSA MOT inspection manual, section 1.2.2: Brake performance and efficiency
- DVSA MOT inspection manual, section 1.4: Parking brake performance
- DVA Light Vehicle Inspection Manual: Brake performance
- DVA Light Vehicle Inspection Manual: Mechanical brake components
- DVSA MOT testing guide: Updates
- DVSA: Testing advice for specific vehicles
PlateScout is independent and not affiliated with the DVLA, DVSA, TfL or any government body. Rules and rates change: always check the official source before you act.
Check a number plate now
See when and where a car was first registered, free and without signing up.